Change Pressure Units; Voltage And Current Measurements - GE Druck DPI 610 IS User Manual

Getting Started

Change Pressure Units

To change the pressure units proceed as follows. If the four units displayed are
not the units required, press TASK and select any task, other than BASIC, press
SETUP and proceed as detailed on page 36. To return to BASIC mode, press TASK
and select BASIC.
In BASIC mode, the unit is configured to carry out basic Pressure to Voltage (P to V)
or Pressure to Current (P to I) tests, a typical test procedure follows.

Voltage and Current Measurements

Connect the electrical input sockets as follows for voltage and current
measurements. Use the test leads provided and DO NOT push bare wires into the
sockets.
Note: Maximum applied voltage = 30V dc,. Maximum input current = 55mA dc
Note: Maximum applied voltage for external loop supply = 30V dc
8
K249 Issue No. 4