Table of Contents
Advertisement
Advanced Task
mA Ramp
Press the OUTPUT key and select mA Ramp in a similar manner to that shown
above.
•
Define ramp required by entering START and END current values as shown
below (e.g.),
•
Connect an external power source as shown on Page 24.
•
Press START (F1) to run the program. A status display CHECK LOOP
indicates a fault in the external loop i.e. supply fault or open circuit .
Note: The ramp cycle (min to max or max to min), is approximately 60 seconds.
•
Press STOP (F1) when running to stop at any point. Press CONTINUE (F1) to
resume from point of pause or RESET (F2) to return to start point.
K249 Issue No. 4
26
Select Output
Advertisement
Table of Contents
