Table of Contents
Advertisement
Advanced Task
mA Step
To select one of the electrical output programs, press the OUTPUT key and
proceed as follows (e.g.),
On selection of (e.g.) Linear, the output display window changes to show the
selected program of output currents (e.g.),
•
Connect an external power source as shown on Page 24.
•
Press RUN (F1) to run program. A flashing status display CHECK LOOP
indicates a fault in the external loop i.e. supply fault or open circuit.
Note: The dwell time at each step is approximately 10 seconds.
•
Press STOP (F1) when running to stop at any point . Press RUN (F1) to
resume.
25
Select Output
K249 Issue No. 4
Advertisement
Table of Contents
