Typical Examples; Example 1; Example 2; Vapor Pressure And Calibration Tables - GE MG-101 User Manual

Field moisture calibration system
Table of Contents

Advertisement

Appendix A. Supplemental Information
A.2 Typical Examples
The following examples show typical calculations based on the equations presented on the previous page.
A.2.1 Example 1
is provided with the MG-101 to enable you to use the field calibration system to check sensor probe
Data Table 2
calibration without calculating the value of p
point temperature by Equation 2 on the previous page. To use
"Dry Gas Setting" and either "High Wet Gas Setting" or "Low Wet Gas Setting." Moving horizontally across the table,
read the generated dew/frost point temperature under the appropriate temperature reading.
Note: The term "Flowmeter" used in the data tables and is equivalent to the word "rotameter" used in this manual.
A.2.2 Example 2
To determine generated dew/frost point temperatures other than those listed in
page must be used, as shown in the following example. If,
Dry Gas first dilution flowmeter setting F
Dry Gas second dilution flowmeter setting F
Wet Gas flowmeter setting = 20 cc/min F
Wet Gas diluted flowmeter setting F
Thermometer reading T = 20°C
and, P
= 17.535 mm Hg at 20°C (from Table 1 on page 19),
s
Then,
------------------------------------------------------------------ -
P w
=
347cc min
And, Pw = 0.0375 mm Hg, which is equivalent to a dew/frost point temperature of 48°C (by interpolation).
A.3 Vapor Pressure and Calibration Tables
Table 1 on page 19 is the vapor pressure of water as a function of temperature.
IMPORTANT: Two tables not included in this manual,
factory for each MG-101. These tables are supplied with the unit, and you must use these tables to
operate the MG-101. Since each table is specific to your instrument, you cannot use tables from another
unit. If you lose these tables, contact the factory and duplicates will be provided.
18
.
Data Table 2
w
= 4,500 cc/min
d1
= 4,500 cc/min
d
= 140 cc/min
w1
= 347 cc/min
w
F
w
------------------ -
P
=
w
F
+
w
347cc min
4500cc min
+
was compiled by calculating p
, set the rotameters per the columns headed
Data Table 2
F
w1
------------------------ -
P
s
F
F
F
+
d
w1
d1
140cc min
------------------------------------------------------------------ -
140cc min
4500cc min
+
, are sets of calibrations generated at the
Data Tables 2 and 3
and thus, the dew/frost
w
Data Table 2
, Equation 2 on the previous
(
)
17.353mmHg
MG-101 User's Manual
(3)
(4)

Advertisement

Table of Contents
loading

Table of Contents