D-Link DGS-3224TG User Manual page 29

DGS-3224TG Gigabit Ethernet Switch User's Guide
•
Disabled – the port only responds to network management messages and must return to the
blocking state first
A port transitions from one state to another as follows:
•
From initialization (switch boot) to blocking
•
From blocking to listening or to disabled
•
From listening to learning or to disabled
•
From learning to forwarding or to disabled
•
From forwarding to disabled
•
From disabled to blocking
When you enable STP, every port on every switch in the network goes through the blocking state and
then transitions through the states of listening and learning at power up. If properly configured, each
port stabilizes to the forwarding or blocking state.
No packets (except BPDUs) are forwarded from, or received by, STP enabled ports until the forwarding
state is enabled for that port.
Figure 5-3. STP Port State Transitions
Default Spanning-Tree Configuration
Feature
Enable state
Port priority
Default Value
STP enabled for all ports
128
19