The information is described as follows:
•
Time Interval – Select the desired setting between 1s and 60s, where "s" stands for seconds.
The default value is one second.
•
Record Number – Select number of times the switch will be polled between 20 and 200. The
default value is 20.
•
64 – The total number of packets (including bad packets) received that were 64 octets in length
(excluding framing bits but including FCS octets).
•
65-127 – The total number of packets (including bad packets) received that were between 65
and 127 octets in length inclusive (excluding framing bits but including FCS octets).
•
128–255 – The total number of packets (including bad packets) received that were between
128 and 255 octets in length inclusive (excluding framing bits but including FCS octets).
•
256-511 – The total number of packets (including bad packets) received that were between
256 and 511 octets in length inclusive (excluding framing bits but including FCS octets).
•
512-1023 – The total number of packets (including bad packets) received that were between
512 and 1023 octets in length inclusive (excluding framing bits but including FCS octets).
•
1024-1518 – The total number of packets (including bad packets) received that were between
1024 and 1518 octets in length inclusive (excluding framing bits but including FCS octets).
•
Show/Hide – Check whether or not to display 64, 65-127, 128-255, 256-511, 512-1023, and
1024-1518 packets received.
•
Clear – Clicking this button clears all statistics counters on this window.
Figure 7-38. Packet Analysis window (Table)
114
DGS-3224TG Gigabit Ethernet Switch User's Guide