Securing The Unit To Prevent Slipping - Henny Penny FlexFusion FPE-615 Installation Manual

Installing the unit
Prerequisite Floor capable of accommodating the weight of the unit

5.6.2 Securing the unit to prevent slipping

24
11.Place retainer on the floor plate and secure using cap nuts.
12.Complete the start-up operation report.
Floor with steam barrier
In the case of floors with a steam barrier, the floor plates are not
screwed to the floor but fastened with the enclosed adhesive.
A
a
d
c
Image: A: Position of floor plate; B: floor plate glued to the floor
a Cap nut
b Holding plate
c Upright bolt
Floor must be clean and suitable for the manner fastening
Unit set up and aligned in accordance with the planning drawing
1. Insert the floor plate from the fastening kit into the retainer as
shown in the drawing.
2. Screw on the cap nuts hand-tight.
3. Align the floor fasteners in position 1-1 or 2-2 on the unit leg or
underframe as shown in the drawing and mark the floor.
4. Screw on cap nuts and remove the retainer from the floor plate.
5. Using the adhesive provided, fasten the floor plates to the floor.
Follow the manufacturer's instructions regarding the adhesive.
Apply the adhesive in accordance with the manufacturer's
instructions.
Observe the drying time specified in the manufacturer's
instructions.
6. Place retainers on the floor plates and secure using cap units.
7. Complete the start-up operation report.
If necessary, the size 2XX combisteamer can be secured to prevent
movement (optional).
Installation instructions
B
e
b
d Floor plate
e Unit leg