Securing The Unit To Prevent Slipping - Henny Penny FlexFusion FPE-615 Installation Manual

Installing the unit
Prerequisite Floor capable of accommodating the weight of the unit

5.6.2 Securing the unit to prevent slipping

28
Floor must be clean and suitable for the manner fastening
Unit set up and aligned in accordance with the planning drawing
1. Insert the floor plate from the fastening kit into the retainer as
shown in the drawing.
2. Screw on the cap nuts hand-tight.
3. Align the floor fasteners in position 1-1 or 2-2 on the unit leg or
underframe as shown in the drawing and mark the floor.
4. Screw on cap nuts and remove the retainer from the floor plate.
5. Using the adhesive provided, fasten the floor plates to the floor.
Follow the manufacturer's instructions regarding the adhesive.
Apply the adhesive in accordance with the manufacturer's
instructions.
Observe the drying time specified in the manufacturer's
instructions.
6. Place retainers on the floor plates and secure using cap units.
7. Complete the start-up operation report.
If necessary, the size 2XX combisteamer can be secured to prevent
movement (optional).
c
1
b
Image: Arrangement of the floor plates (view from above)
a Cooking chamber door
b Unit leg or underframe
A special fastening set with floor plates for securing the unit against
sliding is available from the manufacturer as an accessory.
The fastening kit contains two floor plates and all components
required to bolt or bond to the floor.
Installation instructions
2
a
c Floor plates
2 1