Henny Penny FlexFusion FPE-615 Installation Manual page 34

Connecting the unit
Prerequisite Unit dead
34
• Do not operate the unit with the housing open.
Minimum requirements for the network cable
Type of network
Cable quality
Connection to unit
e
Image: Connecting the kitchen guiding system
a RJ45 socket
b RJ45 connector
c Network cable
Housing opened
1. Pull the network cable into the unit through the cable gland.
2. Route the network cable through the two ferrite rings, with one
winding through each.
3. Connect the network cable to the unit with the RJ45 connector.
4. Register the network in the basic control setting (see "Making the
basic control setting").
5. Fill out the Start-up operation report.
Installation instructions
Ethernet
4-pair shrouded patch cable
Cat-5 S/FTP
Shrouded RJ45 connector
d
c
d Cable ties
e Ferrite ring
a
b