Henny Penny FlexFusion FPE-615 Installation Manual page 21

INFORMATION
Prerequisite The floor under and in front of the unit is flat
Aligning tray trolley
For units on castors, balance the unit by placing washers between the castor
and the frame.
1. Level the unit by screwing the equipment legs in or out.
2. With poor floor conditions, place spacers on the casters of the tray
trolley.
3. Open cooking chamber door.
4. Move tray trolley into the unit until it stops and check the
alignment.
5. Close the cooking chamber door.
The sheet metal sealing strip on the tray trolley should make
full contact (no gaps) with the door seal.
The shelves in the unit are horizontal.
6. Fill out the Start-up operation report.
Aligning tray trolley with insertion system
The Combisteamer can be equipped with the EasyIn insertion system
(optional).
e
d
c
Image: Aligning tray trolley with insertion system
a Tray trolley
b Distance
c Guide rail
1. Level the unit by screwing the equipment legs in or out.
2. Open cooking chamber door.
3. Place the tray trolley against the guide rails.
4. Screw the unit legs in or out until the rollers are 1 mm (0,04 in) —
5 mm (0,2 in) over the guide rails.
5. Retract the tray trolley.
Installation instructions
Installing the unit
b
a
d Unit leg
e Support roller
f Handle bar
f
21