Table of Contents
Advertisement
4.1.2
Connection of tape library to the server via a switch
Zoning must be set for the switch when the tape library is connected to the server via a
switch.
Notes:
1.
2.
1) Check the World Wide Port Name (WWPN) of the tape library. Use one of the
% telnet
Fabric OS (tm)
login: admin
Password: ***********
WARNING: sensor 12 (Power Supply #1) is faulty
switch:admin> nsShow
The Local Name Server has 4 entries {
Type Pid
N
021100;
Fabric Port Name: 20:01:00:60:69:20:5d:5a
NL
021226;
3;50:05:07:63:00:40:9c:b0;50:05:07:63:00:00:9c:b0; na
FC4s: FCP [IBM
Fabric Port Name: 20:02:00:60:69:20:5d:5a
NL
021326;
3;50:05:07:63:00:40:9b:06;50:05:07:63:00:00:9b:06; na
FC4s: FCP [IBM
Fabric Port Name: 20:03:00:60:69:20:5d:5a
NL
021426;
3;50:05:07:63:00:40:9b:87;50:05:07:63:00:00:9b:87; na
FC4s: FCP [IBM
Fabric Port Name: 20:04:00:60:69:20:5d:5a
NL
021526;
3;50:05:07:63:00:40:9b:3e;50:05:07:63:00:00:9b:3e; na
FC4s: FCP [IBM
Fabric Port Name: 20:05:00:60:69:20:5d:5a
N
021600;
FC4s: FCP [FUJITSU NML9A
Fabric Port Name: 20:06:00:60:69:20:5d:5a
}
Topology
C144-E073-01EN
The zoning depends on the type of connection. Since the tape library and tape drive
cannot be recognized if the zoning is done incorrectly, perform the zoning that is
appropriate for the operating mode.
See
Section 3.1.2, "Connection to a server via a switch,"
connection type.
following methods to check the WWPN.
a) Confirmation using the switch
If you connect to the switch using telnet and execute the nsShow command, the
WWPN of each port is displayed as shown below.
switch
Release v2.1.9d
COS
PortName
3;21:00:00:e0:8b:03:90:99;20:00:00:e0:8b:03:90:99; na
ULTRIUM-TD1
ULTRIUM-TD1
ULTRIUM-TD1
ULTRIUM-TD1
3;21:00:00:00:0e:da:07:89;20:00:00:00:0e:da:07:89; na
Port-ID
WWPN (World Wide Port Name)
The Port ID has the following format:
AABCDD
for an example of the
NodeName
22U0]
22U0]
22U0]
22U0]
0001]
WWNN (World Wide Node Name)
4.1 Setting Solaris
TTL(sec)
4-3
Advertisement
Table of Contents
