Table of Contents
Advertisement
Setting the Fibre Channel Interface
3.2.1.2 Setting the host WWPN enabled for each adapter
Set the host WWPN that will be allowed to access an adapter port. (*1)
Up to eight hosts can be set for each adapter.
*1 If a host WWPN is not set, access to every host is enabled.
1) Click the [Host WWPN] button.
2) Select the number of a connected adapter.
3) Specify the host WWPN that will be permitted to access the selected adapter.
3-12
If a host WWPN is set, only the relevant host can access the corresponding adapter.
SETUP menu
-Host I/F
-Host WWPN
+Adapter#0
+Adapter#1
•
Select a host WWPN from the host WWPN list.
Click the [List] button to display a list of registered host WWPNs. Select a host
WWPN from the list.
Note:
See
Section 3.2.1.3, "Registering host WWPNs in a list,"
how to prepare a list of host WWPNs.
•
Enter a host WWPN directly.
Select the numeric keypad icon and use the numeric keypad to enter the WWPN
directly. The specified WWPN is also added to the host WWPN list.
Note:
By default, adapters can be accessed from all hosts.
for information about
C144-E073-01EN
Advertisement
Table of Contents
