Setting The Drive Interface - Fujitsu ETERNUS LT160 Setup Manual

3.2.2

Setting the drive interface

Set the Target ID of each drive.
Click the [Drive] button on the SETUP menu.
Specify a drive using the [Drive Number] button.
(1) Setting the Loop ID for Fibre Channel connection
When a Fibre Channel connection is used, the Loop ID must be set.
1) Select the Addressing mode.
C144-E073-01EN
SETUP menu
-Drive
+DRV#00
+DRV#01
To directly specify the Loop ID, click the [Hard Address] button.
SETUP menu
-Drive
-DRV#00
+Hard Address
To automatically set the Loop ID, click the [Soft Address] button.
SETUP menu
-Drive
-DRV#00
+Soft Address
3.2 Settings for Fibre Channel Connection
3-15