Table of Contents
Advertisement
Chapter 4 Setting the Operating System
4.1
4.2
This chapter explains how to set each operating system that is required to use the tape
library.
Notes:
1.
2.
4.1
Setting Solaris
This section explains how to set Solaris.
The driver for each Fibre Channel adapter must be installed, and the st driver and lus
driver must be set (see
Notes:
1.
2.
The following st driver-related patches must be applied the first time that Solaris is used:
•
•
•
Download required patches from the URL for downloading Fujitsu patches
(http://software.fujitsu.com/en/security/main.html).
Notes:
1.
2.
C144-E073-01EN
Setting Solaris
Setting Windows NT 4.0/Windows 2000
Refer to the manual of the applicable operating system for information about how to
perform operations in that operating system.
Special setting for the tape library is not required for the operating system unless it is
noted in this manual.
Section 5.3.2
Refer to the "Fujitsu PCI Fibre Channel Installation Guide" for information about
installing the fjpfca driver.
Be sure to use version 2.2 or later of the fjpfca driver. Execute the pkginfo-l
FJSVpfca command to check the version. Also confirm that patch 910936-06 or
later has been applied. Execute the showrev -p command to check the patch version.
Solaris 2.6 (105847-13)
Solaris 7 (107460-12)
Solaris 8 (108725-09)
These patches are applied when the latest PTF is applied.
Be sure to apply these patches before the st driver is set. If the patches are applied
after the st driver has been set, the settings may be cleared.
when Legato NetWorker is used).
4-1
Advertisement
Table of Contents
