Fujitsu ETERNUS LT160 Setup Manual page 48

Setting the Fibre Channel Interface
1) Create a table such as the one shown below to examine the zoning configuration.
LT160
connec-
tion port
2) Establish a connection to SN200 using telnet and log in to the switch.
3) Use the aliCreate command to assign a zone alias name to the port connected to the
3-22
Switch
(SN200)
Port#
Port# ZoneAlias
2 LT160_L0
3 LT160_D0
4 LT160_D1
Enter the numbers of
the ports to which the
LT160 is connected.
tape library and the port connected to the server.
aliCreate "zone-alias-name" "physical-switch-port-number"
"zone-alias-name" is the alias to be assigned to the physical switch port number. The
zone alias name must be specified only with alphanumeric characters (A to Z, a to z,
0 to 9) and the underscore (_). The zone alias name is case-sensitive. The zone alias
name must begin with a letter.
The physical switch port number can be specified in the following format:
switch-domain ID, port-number
Specify the switch domain ID and port number separated with a comma.
Example of setting
aliCreate "HOST_A0"
aliCreate "HOST_B0"
aliCreate "LT160_L0" "1,2" ← Assign zone alias name
aliCreate "LT160_D0" "1,3" ← Assign zone alias name
aliCreate "LT160_D1" "1,4" ← Assign zone alias name
Server connection port
0 1
HOST_A0 HOST_B0
ZONE1 -
ZONE1 -
-- ZONE2
Enter zone aliases
that can be set for
the ports.
"1,0" ← Assign zone alias name
HOST_A0 to port #0.
"1,1" ← Assign zone alias name
HOST_B0 to port #1.
LT160_L0 to port #2.
LT160_D0 to port #3.
LT160_D1 to port #4.
Enter the numbers
of the ports to
which the servers
are connected.
Enter zone names
for the intersections
of the ports to be
zoned.
C144-E073-01EN