System Parameter Settings - Fujitsu ETERNUS LT160 Setup Manual

Setting Backup Software
5.1.5

System parameter settings

When NetBackup from VERITAS is installed on a Solaris server, system IPC resources
must be added for NetBackup interprocess communication.
While referring to the recommended minimum settings for the NetBackup system
parameters listed below, specify additional entries in the /etc/system file on the
NetBackup master server and each media server. After that, reboot.
The existing system parameter settings can be verified with the sysdef -i command.
* BEGIN NetBackup recommended minimum settings
* Message queues
set msgsys:msginfo_msgmap=512
set msgsys:msginfo_msgmax=8192
set msgsys:msginfo_msgmnb=65536
set msgsys:msginfo_msgmni=256
set msgsys:msginfo_msgssz=16
set msgsys:msginfo_msgtql=512
set msgsys:msginfo_msgseg=8192
* Semaphores
set semsys:seminfo_semmap=64
set semsys:seminfo_semmni=1024
set semsys:seminfo_semmns=1024
set semsys:seminfo_semmnu=1024
set semsys:seminfo_semmsl=300
set semsys:seminfo_semopm=32
set semsys:seminfo_semume=64
* Shared memory
set shmsys:shminfo_shmmax=16777216
set shmsys:shminfo_shmmin=1
set shmsys:shminfo_shmmni=220
set shmsys:shminfo_shmseg=100
* END NetBackup recommended minimum settings
Note the following when setting the system parameters.
5-4
(Only for Solaris 2.6 or 2.7)
(Only for Solaris 2.6 or 2.7)
(Only for Solaris 2.6 or 2.7)
(Fixed value: 1)
C144-E073-01EN