Setting Backup Software
5.3.3
Notes on operation
(1) If backup and recovery are executed simultaneously, either backup or recovery may
(2) Before using the library initialization command nsrjb -H to replace the tape, execute
(3) The LT160 does not support the Fast Load function. Specify Disable (default) for
Note:
If backup is performed using a partition (UFS) that is two gigabytes or more when the file
system is full, an error may occur at recovery time. If an error occurs, perform recovery
processing for a partition that is larger than the backup source.
5-10
not end normally. Execute recovery after backup is completed.
If either backup or recovery did not end normally, take the following actions:
1) Use the ps command to check the process number of the recovery processing
that did not terminate normally.
# ps -ef | grep recover
2) Kill the recover process that did not terminate normally.
# kill -9 "process-number"
3) Unload the tape from the drive.
# nsrjb -u
4) Reset the autochanger.
# nsrjb -H
5) Make sure that the tape is returned to the slot, then execute inventory processing.
# nsrjb -I -S "slot-number" -j "autochanger-name"
6) Execute the recovery (recover) again.
the nsrjb -u command.
the LT160 Fast Load function.
C144-E073-01EN