Chapter 5 Configuration Procedures For The Cisco 67X Cpe Devices; Introduction; Configuration Checklist; Table 5-1 Checklist For Router Configuration - Cisco 678 Installation And Operation Manual

Configuration Procedures for the
Cisco 67x CPE Devices

Introduction

This chapter provides information about configuring the Cisco 67x CPE devices.
This information applies to the Cisco 673, Cisco 675, Cisco 675e, Cisco 676,
Cisco 677, and Cisco 678.
Cisco recommends that only one command-line application at a time
Note
be used to configure the Cisco 67x. For example, Telnet and the
serial management interface should not be used simultaneously.
Also, please note that all configuration procedures are performed in
the enable mode.

Configuration Checklist

Table 5-1
78-11190-01
Checklist for Router Configuration
Configuration Procedures
Log On to the Cisco Broadband Operating System
Determine the CBOS Version
Select a Connection Mode
C H A P T E R
Cisco 600 Series Installation and Operation Guide
5
Page Number
5-3
5-3
5-5
5-1