Cisco 678 Installation And Operation Manual page 91

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
To manage the bridged Cisco 67x using a separate management VC:
To disable in-band bridging management, enter:
Step 1
set bridging management disabled
To enable bridging PVC, enter:
Step 2
set bridging PVC enabled
To save your changes, enter:
Step 3
write
To reboot the device, enter:
Step 4
reboot
After rebooting, the Cisco 67x will have two PVCs enabled. Wan0-0 is used
strictly for bridged traffic, while wan0-1 is used strictly for management traffic.
Wan0-1 will be using RFC 1483 routing.
Set an IP address on the Ethernet port that is on the same network as the far-end
Step 5
station out the wan0-1 interface:
set int eth0 address ip address
For more information on using the set bridging command, see the Cisco
Broadband Operating System User Guide.
The rules that govern the bridge command are:
•
•
•
78-11190-01
Bridging and routing do not operate simultaneously on the Cisco 67x ADSL
router.
Only one bridging mode is allowed at any one time (that is, RFC 1483 or
PPP/BCP, not both).
The following commands do not work while in bridge mode:
set route (and setting static routes)
–
RIP-related commands (set and show)
–
Filter-related commands (set and show)
–
Web interface (only allowed if management is enabled)
–
Cisco 600 Series Installation and Operation Guide
Bridging Mode Procedures
5-7