Cisco Asr 920-10Sz-Pd And Cisco Asr-920-8S4Z-Pd Routers Initial Configuration; Checking Conditions Prior To System Startup; Powering Up The Router - Cisco ASR-920-8S4Z-PD Hardware Installation Manual

Cisco ASR 920-10SZ-PD and Cisco
ASR-920-8S4Z-PD Routers Initial Configuration
This chapter guides you through a basic router configuration, which is sufficient for you to access your network.
Complex configuration procedures are beyond the scope of this publication and can be found in the modular
configuration and modular command reference publications in the Cisco IOS-XE software configuration
documentation set that corresponds to the software release installed on your Cisco hardware.
To configure Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Routers from a console, connect a
terminal to the router console port.
This chapter contains the following sections:
•
•
•
•

Checking Conditions Prior to System Startup

Ensure that the following conditions are addressed before starting up the router:
• The optional Gigabit Ethernet Management port cable is installed.
• The chassis is securely mounted and grounded.
• The power and interface cables are connected.
• Your PC with terminal emulation program (HyperTerminal or equivalent) is connected to the console
• Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop-bit, no parity, and
• You have selected passwords for access control.
• You have determined the IP addresses for the Ethernet and serial interfaces.

Powering Up the Router

After installing your router and connecting cables, start the router and follow these steps:
Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Aggregation Services Router Hardware Installation Guide
Checking Conditions Prior to System Startup , on page 57
Powering Up the Router, on page 57
Configuring the Router at Startup, on page 62
Safely Powering Off the Router, on page 65
port and powered up.
no flow control is set to none.
4
C H A P T E R
57