Enable Ip Filtering - Cisco 678 Installation And Operation Manual

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Step 4
Step 5
Step 6
Enable Routing Information Protocol (RIP)

Enable IP Filtering

78-11190-01
To set a destination address for each VC, enter:
set interface wan0-0 dest 192.168.245.228
mask 255.255.255.0
To save your changes, enter:
write
To exit the CBOS, enter:
quit
For more information on using the set route command, see the Cisco Broadband
Operating System User Guide.
To enable RIP and RIP2 in CBOS, enter:
set rip enabled
To disable RIP, enter:
set rip disabled
For more information on using the set rip commands, see the Cisco Broadband
Operating System User Guide.
The Cisco 67x supports up to 20 filters for TCP and UDP packets passing through
the Cisco 67x's interfaces. Enabled filters are applied to packets in sequential
order according to filter number.
To use filtering to block all packets going through the Ethernet interface, enter:
set filter 0 on deny eth0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0
For more information on using the set filter command, see the Cisco Broadband
Operating System User Guide.
Cisco 600 Series Installation and Operation Guide
Enable IP Filtering
5-17