Cisco 678 Installation And Operation Manual page 98

Configure the WAN Ports and ATM Virtual Connections
Step 3
Step 4
Step 5
Step 6
Step 7
Changing VCI Settings
Step 1
Step 2
Step 3
Step 4
Step 5
Cisco 600 Series Installation and Operation Guide
5-14
To enable the wan0-0 connection, enter:
set interface wan0-0 enable
To begin using this connection with the new settings, enter:
set interface wan0-0 open
Repeat steps 2 through 4 for every VPI assignment you want to make.
To save the new WAN port configuration, enter:
write
To exit CBOS, enter:
quit
To make sure the wan0-0 connection remains closed during configuration, enter:
set interface wan0-0 disable
To set the VCI number to 4, enter:
set interface wan0-0 vci 4
If you try to enter the command set interface wan0-0 on a
Note
connection that is already open, the system prompts you to
close that connection before you change the VCI setting. To
do this, enter the command set interface wan0-0 close.
To enable the wan0-0 connection, enter:
set interface wan0-0 enable
To begin using this connection with the new settings, enter:
set interface wan0-0 open
Repeat steps 2 through 4 for every VCI assignment you want to make.
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
78-11190-01