Configure Applications; Dhcp Client - Cisco 678 Installation And Operation Manual

Configure Applications

Configure Applications

DHCP Client

Note
Step 1
Step 2
Step 3
Step 4
Cisco 600 Series Installation and Operation Guide
5-18
The Cisco 67x supports these applications for system management and control:
DHCP client
•
DHCP server
•
NAT
•
RADIUS client
•
SNMP
•
SYSLOG client
•
Telnet server
•
TFTP server
•
Web server (HTTP server)
•
The DHCP client requests an IP address from a DHCP server. To enable the DHCP
client:
Enabling the DHCP client automatically disables the DHCP server
on the CPE.
Enable the DHCP client:
set dhcp client enabled
To change the DHCP client interface, enter:
set dhcp client interface eth0
To check whether this feature is enabled, enter:
show dhcp client
Write the changes to NVRAM:
write
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
78-11190-01