Chapter 5
Configuration Procedures for the Cisco 67x CPE Devices
Step 3
Step 4
Step 5
Configure Line Coding (Cisco 677 and Cisco 678 only)
Note
Configure for CAP
Step 1
Step 2
78-11190-01
To verify these values, enter:
show timeout
To save your changes, enter:
write
To exit CBOS, enter:
quit
The Cisco 677 and Cisco 678 allow you to choose transmission protocols to match
your network configuration by changing the router's configuration file. Use TFTP
to transfer files to and from a CPE. This section describes procedures to configure
the CPE for Discrete Multi-Tone (DMT), Carrierless Amplitude and Phase
Modulation (CAP), G.Lite, or G.DMT protocols.
Changes to your CPE must be coordinated with the central office
equipment. Not all protocols described here are available on all CPE
models.
Verify the connection from the router to the location where the correct software
image is stored. This location is provided by your network administrator.
Typically, you use the ping command for this step.
Enable TFTP:
cbos#set tftp enabled
TFTP is enabled
Configure Line Coding (Cisco 677 and Cisco 678 only)
Cisco 600 Series Installation and Operation Guide
5-31