Cisco 678 Installation And Operation Manual page 68

Configure Line Coding
Configure for G.DMT
Step 1
Step 2
Cisco 600 Series Installation and Operation Guide
3-16
Finished. Rebooting...
Hello!
Expanding CBOS image...
CBOS v2.3.5.012 - Release Software
User Access Verification
Password:
cbos>enable
Password:
cbos#show version
Cisco Broadband Operating System
CBOS (tm) 627 Software (C627-I-M), Version v2.3.0.053, RELEASE
SOFTWARE
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Feb 13 2000 17:36:16
Monitor build 111 (Feb 13 2000 17:37:07)
Before the CPE can be configured for G.DMT, the .full image must be loaded. See
the latest Release Notes for the Cisco Broadband Operating Sytsem for the
appropriate filenames to use. The central office hardware must be correctly
configured to accept a G.DMT service user.
Enter the following command:
cbos# set interface atm1 standard g.992.1
Be sure to retrain the CPE to activate the new line code. When the CPE is
retrained, use the show interface atm1 command to verify the G.DMT standard
is active. Note that the standard configuration for the .full image is DMT2.
Changes made to the running configuration must be written
Note
to NVRAM for changes to be seen on reboot.
Chapter 3 Configuration Procedures for the Cisco 627
78-11190-01