Cisco 678 Installation And Operation Manual page 116

Configure Line Coding (Cisco 677 and Cisco 678 only)
Set the remote address for the TFTP host computer:
Step 3
cbos # set tftp remote ip address
This command tells the CPE to accept TFTP transfers from a specific IP address.
An example remote IP address would be 192.168.35.4. This address is an example
only; do not use it to configure the router.
Note
To start the file transfer from a PC, start a DOS session and enter the following
Step 4
command:
C:>tftp –i CPE IP address put image_filename
Where necessary, implement the following values:
-i
put
To start the file transfer from a UNIX machine, enter:
root@staten-</678>tftp
tftp> mode binary
tftp> put CPE IP address:image_filename
Sent 922294 bytes in 54.9 seconds
Substitute the file name for the software image update. Files use the naming
format c67ycap.x.x.x.x.bin, where 67y is the CPE model number, and x.x.x.x is the
image version number.
Do not turn off the power to the router until after the file transfer is
Caution
completed.
Cisco 600 Series Installation and Operation Guide
5-32
Chapter 5
If you do not have the CPE address, consult your network
administrator.
For more information about TFTP, see the
section on page 5-27.
Sets the transfer mode to binary mode
Uploads a file onto that IP address
Configuration Procedures for the Cisco 67x CPE Devices
"TFTP Server"
78-11190-01