Cisco 678 Installation And Operation Manual page 105

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Cisco 67x Implementation
Configuring RADIUS on the Cisco 67x
Note
Step 1
Step 2
Step 3
Step 4
78-11190-01
CiscoSecure for UNIX
•
CiscoSecure for Windows NT
•
The Cisco 67x supports a RADIUS client. However, for most environments, the
Cisco 67x RADIUS client is not used. The RADIUS profile exists on the service
provider's remote access server.
The following examples assume that the Cisco 67x is connected to a network
equipped with a RADIUS server:
If you enable RADIUS on the CPE, you have to disable
authentication on the service provider's remote access server.
Enable the Cisco 67x RADIUS application:
set radius enabled
RADIUS is enabled
Point the CPE to the remote RADIUS server:
set radius remote x.x.x.x
RADIUS will now send messages to x.x.x.x
where x.x.x.x is the address of the remote RADIUS server.
Set the RADIUS secret password:
set radius secret mysecret
RADIUS Secret now set - All secrets are in lowercase
where mysecret is the RADIUS secret password.
Enable RADIUS authentication and set the PPP login and password for the
WAN0-0 port:
set ppp wan0-0 radius enabled
set ppp wan0-0 login cisco
set ppp wan0-0 password is_great
Cisco 600 Series Installation and Operation Guide
Configure Applications
5-21