Chapter 2
Installation Procedures
Cabling Instructions
Step 1
Step 2
78-11190-01
Figure 2-13 Rear Panel Cabling for the Cisco 675 and Cisco 678
PWR
Power
cable
To connect the cables to the Cisco 600 series CPE:
Plug the power cable into the back of the unit.
Plug the network cable into the ATM25 port of the Cisco 627, or the ENET port
of the Cisco 67x.
For the Cisco 633, connect one end of the serial cable to the SERIAL port.
Connect the other end to your router.
WALL
ENET
MGMT
ADSL
Ethernet
cable
cable
Cisco 600 Series Installation and Operation Guide
Set Up the Hardware Environment
PHONE
Phone
cable
2-17