Update The Cbos Prompt - Cisco 678 Installation And Operation Manual

Update the CBOS Prompt

Update the CBOS Prompt
Step 1
Step 2
Step 3
Step 4
Cisco 600 Series Installation and Operation Guide
3-18
Interleaved Symbols with CRC Errors:
No Cell Delineation Interleaved:
Out of Cell Delineation Interleaved:
Header Error Check Counter Interleaved:0
Count of Severely Errored Frames:
Count of Loss of Signal Frames:
Remote Counters:
Interleaved RS Corrected Bytes:
Interleaved Symbols with CRC Errors:
No Cell Delineation Interleaved:
Header Error Check Counter Interleaved:0
Count of Severely Errored Frames:
Count of Loss of Signal Frames:
The default Cisco 627 system prompt is
to 8 characters. You can change this prompt to a unique subscriber identifier as
shown in the following example.
Log on to the CBOS using either the serial or Telnet interfaces. Refer to the
"Using Telnet" section on page 3-6
log on to the CBOS.
To change the default prompt to 4412883 as the subscriber identifier, enter:
cbos# set prompt 4412883
4412883#
To save your changes, enter:
4412883# write
To exit the CBOS, enter:
4412883# quit
Chapter 3 Configuration Procedures for the Cisco 627
2
0
0
0
0
0
0
0
0
0
. The command prompt is limited
cbos#
for more information on how to use Telnet to
78-11190-01