Cisco 678 Installation And Operation Manual page 113

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
-rw-r--r-- 1 root
-rw-r--r-- 1 root
-rw-r--r-- 1 root
-rw-r--r-- 1 root
Using TFTP from a Windows NT Machine
Step 1
Step 2
Step 3
Step 4
Attention Windows 95/98 Users
78-11190-01
The CPE displays the following when the image is being upgraded:
cbos>
Downloading legacy image..... done.
Saving image................. done.
Please reboot the CPE for the new download to take effect
The released images come in two file formats:
other 924976 Jan 31 09:04 c678cap.2.3.5.012.bin
other 922336 Jan 31 09:04 c678dmt.2.3.5.012.bin
other 924870 Jan 31 09:04 nsrouter.c678cap.2.3.5.012.bin
other 922230 Jan 31 09:04 nsrouter.c678dmt.2.3.5.012.bin
Enable the tftp server on the Cisco 67x. As an enabled user, enter:
set tftp enabled
Start a DOS session and enter:
C:>tftp -i ip address of Cisco 67x put image_filename
Where necessary, implement the following options:
-i—Sets the transfer mode to binary mode (all router images)
put—Uploads a file to a specified IP address
Use the show errors command to verify that TFTP is working.
Be sure that you reboot the device to activate the new image.
When you log back in to the Cisco 67x after the reboot, use the following
command to verify the version of the firmware that is active:
show version
Windows 95/98 does not have a TFTP client. If you want to utilize TFTP on a
Windows 95/98 system, you must install a TFTP client from a third-party vendor
on your system. One way to locate a TFTP client is to use an Internet search
Cisco 600 Series Installation and Operation Guide
Configure Applications
5-29