Removing/Fitting The Cable Pulleys - Jonsered FR 13 Workshop Manual

Repair Instructions

Removing/Fitting the Cable Pulleys

1
Remove the frame plate.
2
Loosen the steering cables' rear fixture (1).
3
Remove the screw (2) and remove the cable pulley
(5).
4
Remove the bearing's circlip (3) and tap out the
bearing (4).
5
To assemble the cable pulley, follow the instructions
in the reverse order.
The screw (2) is to be mounted in the rear hole on
the frame. The bushing (6) is to be placed between
the frame and the cable pulley.
28
– English
Ensure that the cables are properly situated under
the steering cable pulleys (7) in the frame tunnel.
Ensure that the steering wheel is in the centre
position when the rear wheels are centred. Re-set
the chain on the steering column's sprocket or
adjust the rear fixture (1) for the steering cables (1)
as needed.
Hold the cables with, for example, a wrench when
mounting so that they do not twist.
After mounting, the cable tension should be
checked (see Checking and Adjusting the Steering
Cables).
6019-005