Checking And Adjusting The Accelerator; Replacing The Articulated Steering Bearings - Jonsered FR 13 Workshop Manual

Checking and Adjusting the Accelerator

Hydrostatic Machines
1
Loosen the lock nut (1) on the ball joint.
2
Push the locking spring (2) back far enough for the
socket (3) to be lifted from the ball on the lever arm
(4).
3
Depress the accelerator pedal completely and use
a screwdriver to move the lever arm (4) forward as
far as possible.
4
Adjust the socket (3) position on the draw bar (5)
so that it fits exactly over the ball on the lever arm.
Fit the socket on the ball.
5
Lock the adjustment in place with the lock nut (1)
and push the locking spring (2) into place.
IMPORTANT INFORMATION
Make sure that the locking spring goes
through the hole in the socket.
5
1
Replacing the Articulated Steering
Bearings
1
• Remove the engine as previously described
(see Removing the Engine).
8009-209
• Jack up the rider in front of the articulated
steering bearings.
2 FR 13, FR 2111
• Loosen the idler's spring (1).
• Loosen the clutch, gear, and brake cables (2, 3
and 4) and remove the cables' mounting plates
(5 and 6).
2. Hydrostatic Machines
2
• Loosen the idler's spring (1).
• Loosen the hydrostatic transmission cable (2) from
3
the arm (3) and the casing from the fixture (4).
• Loosen the cable from the neutral position
contact (5).
4
• Loosen the brake cable from the arm under the
tank and the casing mounting from the rear
8009-210
frame (6)
Repair Instructions
6012-023
6012-024
8009-211
31
English –