Cleaning; Removing Of The Machine Hoods - Jonsered FR 2213 MA Operator's Manual

Cleaning

Clean the machine directly after use. It is much easier to wash
off grass cuttings before they dry.
IMPORTANT! Always park the machine on a level surface
with the engine OFF before performing any maintenance.
Oily dirt can be removed using a cold degreasing agent.
Spray on a thin layer.
Rinse at normal water pressure.
Do not direct the jet towards electrical components or
bearings.
Do not rinse hot surfaces such as the engine and exhaust
system.
It is recommended that you start the engine and run the
mower for a short period after cleaning, so that any remaining
water is blown off.
Lubricate the machine if necessary after cleaning. Carry out
extra lubrication when the bearings have been exposed to a
degreaser or a water jet.
IMPORTANT! Avoid using a high pressure washer or a
steam cleaner.
There is a major risk of water penetrating into bearings and
electrical connections. Corrosion attack can result, which
will lead to running problems. Cleaning additives generally
aggravate the damage.
18 –
English
Maintenance

Removing of the machine hoods

Engine cover
The engine becomes accessible for service when the engine
cover is opened.
Fold the seat forward, loosen the snap lock under the seat
and fold the cover backwards.
Front cover
Release the clip on the front hood and lift off the fender.
Right-hand fender
Dismantle the foot-plate (1), screws (2 and 3), and lift off the
fender.
Left-hand fender
Remove the screws holding the wing cover (2) and lift off the
cover.