Airing The Hydrostatic Transmission's Oil System; Adjusting The Transmission's Neutral Position - Jonsered FR 13 Workshop Manual

Repair Instructions
Airing the Hydrostatic Transmission's
Oil System
1
• Check the oil level in the hydrostatic transmis-
sion.
• Start the engine and set the accelerator to idle.
2
• Repeatedly engage and disengage the clutch
while alternately depressing the forward and
back pedals.
• When the rider begins to move, the throttle
should be increased to high engine speed.
3
• Repeat quick starts and emergency stops until
the transmission responds properly.
• Check the oil level in the hydrostatic transmission
and fill as needed.
4
Check the oil level after test running and top up as
needed.
42
– English
Adjusting the Transmission's Neutral
Position
1
Air the hydrostatic transmission's oil system.
2
Lift the rear of the rider so that the wheels spin
freely and place jack stands under the machine.
3
6012-057
• The neutral position is adjusted by turning the
hexagonal shaft on the transmission (see illustra-
tion).
• Start the engine and turn the throttle to full.
• Loosen the lock nut on the hexagonal shaft and
turn the shaft clockwise until the drive axles
begin to rotate backwards.
• Make a mark on the top of the shaft.
8009-142
8009-130