Wheels - Jonsered FR 13 Workshop Manual

Checking the Oil Level in the
Transmission
(Not FR 13, FR 2111)
Remove the transmission cover. Loosen both
screws (one on each side) and lift off the transmis-
sion cover.
Check that there is oil in the transmission's oil tank.
Fill if necessary with engine oil, SAE 10W/30
(class SF–CC).
IMPORTANT INFORMATION
Check and top up the oil after test
running as well. If there are air pockets
in the transmission, the oil level will fall.

Wheels

Fit the wheels (certain markets).
The air pressure in the tyres should be 60 kPa
2
(0.6 kp/cm ) on all wheels.
In order to improve the drive power, the pressure in
the rear tyres can be reduced to 40 kPa
2
(0.4 kp/cm ).
The highest permitted pressure is 100 kPa
(1.0 kp/cm 2 ).
IMPORTANT INFORMATION
Different air pressures in the front tyres
will result in the blades mowing the grass
at different heights.
Checking and Adjusting the Cutting
Unit's Ground Pressure and Parallelism
Performed after checking the tyre air pressures.
See the appropriate sections in this workshop
manual.
Delivery Procedures
8009-273
6008-240H
8009-268
13
English –