Fitting The Engine - Jonsered FR 13 Workshop Manual

Fitting the Engine

IMPORTANT INFORMATION
When fitting the engine it is important
that the belt pulley's groove (1) is in such
a position that the outgoing shaft's key
(2) fits into the groove (see illustration).
Also check that both the spacing tube (3)
and key (2) are well fitted to the engine
shaft. Grease the engine shaft.
1
Lower the engine into place and tighten the engine
fixtures (two on each side of the engine) with a
torque of 25 Nm.
2
6019-039
Fit the belt pulley with tool no. 506 79 06-01 and
tighten with a torque of 80 Nm. Use tool no.
506 89 92-01 to counter.
3
Place the cables in the cable holder, pinch the
holder together, and push it upwards from below
through the centre of the belt adjuster until it
catches on the upper edge of the adjuster. Ensure
that the hydrostatic transmission cable lies lowest
on machines with a hydrostatic transmission.
4
8009-117
Attach the throttle cable to the throttle and fit the
cable clip without tightening it.
Repair Instructions
6012-008
6012-007
6008-032
23
English –