Delivery And Dealer Service - Jonsered FR 13 Workshop Manual

Rider
Table of Contents

Advertisement

Delivery Service
1. Fill the battery with battery acid and charge for four hours.
2. Fit the steering wheel, towing hook, and where applicable other components.
3. Adjust the cutting unit:
Adjust the lifting springs (the "weight" of the cutting unit should be 12-15 kg, if a brush is to be used,
set to maximum spring power). (Applies to FRM 13 A, FR 2113 MA, FR 2115 MA.)
Adjust the cutting unit so that its rear edge is about 2-4 mm higher than its front edge.
Adjust the cutting unit's cutting height setting so that the cutting height limit is 5 mm above the unit's
frame at the lowest cutting height.
4. Check that the right amount of oil is in the engine.
5. Check that the right amount of oil is in the transmission (not FR 13, FR 2111).
6. Check and adjust the air pressure in the tyres (60 kPa, 0.6 bar).
7. Connect the battery.
8. Fill the fuel tank and start the engine.
9. Check that the machine does not move in neutral. (Not FR 13, FR 2111).
10. Check:
Driving forwards.
Reversing.
Engaging the blades.
The safety switch in the seat.
The safety switch in the lifting lever.
11. Check the engine speed, 2,900 - 3,100 rpm.
12. Inform the customer about:
The need and benefit of following the service schedule.
The need and advantages of leaving the machine for service every 300 hours.
The effects of maintenance on the machine's second hand value.
Application areas for mulching.
13. Fill in the sales papers, etc.
After the First 5 Hours
1. Change engine oil.

Delivery and Dealer Service

7
English –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Frm 13 aFr2111Fr2113aFr2113maFr2115ma

Table of Contents