Cleaning The Rollers - GBC 27C Installation & Operation Manual

Operating Instructions
R I
EMOVING AND NSTALLING THE
S
HIELD
The safety shield should not be removed except to
install films and when cleaning the rollers. When the
shield is off, the laminator runs at a fixed speed of 3
fpm (0.9 m).
WARNING: Keep fingers and hands away from
the rollers when the machine is running. They could
be trapped and crushed in the rollers. Clothing,
jewelry, and long hair could be caught in the rollers
and pull you into them.
Safety shield
Feed table
Interlock latch
(under table)
Fig. 6-4. Safety Shield and Feed Table.
To remove the shield:
1. Lift the front edge of the shield.
2. Lift and slide the back of the shield towards the
back of the machine and lift the shield off.
To install the shield:
1. Place the pins at the back of the shield in the
slots on the machine.
2. Lower the front edge of the shield, making sure
that the front guides engage the safety switches.
S R
AFETY
T
The feed table should not be removed except to
install films. When the table is off, the laminator runs
at a fixed speed of 3 fpm (0.9 m). Refer to Fig. 6-4 for
the following instructions.
To remove the feed table:
1.
2.
To install the feed table:
1.
2.
I
EMOVING AND NSTALLING THE
ABLE
Slide the feed table latch to the right.
Lift the table upwards and away from the
laminator.
Place the table on the machine.
Slide the feed table latch to the left.
27C
F
EED
Page 6-3