Unintended Use - Bosch Rexroth VAM 10.2 Project Planning Manual

10/69 Bosch Rexroth AG
Important Instructions on use
3.2

Unintended use

Rexroth IndraControl VAM 10.2/40.2 Machine Control Panels
Typical areas of application of the machine control panels IndraControl
VAM 10.2/VAM 40.2 are:
● Lathes
● Milling machines
● Machining centers
Machine control panels of the type IndraControl VAM 10.2/VAM 40.2 may on‐
ly be operated under the mounting and installation conditions, position, and
the ambient conditions (temperature, degree of protection, humidity, EMC
etc.) specified in the related documentation.
Any use of IndraControl VAM 10.2/VAM 40.2 in applications other than those
specified above or under operating conditions other than those described in
the documentation and the technical specifications is considered to be "unin‐
tended".
The machine control panels VAM 10.2/VAM 40.2 may not be used if ...
● the machine control panels are exposed to operating conditions which
do not correspond to the specified ambient conditions. Operation under
water, extreme temperature fluctuations or extreme maximum tempera‐
tures
● the intended applications have not expressly been approved by Bosch
Rexroth. Please do observe the general safety instructions!
DOK-SUPPL*-VAM*XX.2***-PR03-EN-P