1-4-11. Center Cabinet
n
The identical parts are used for the two center cabinets. Therefore, they can be attached to either the front
or rear side of the camera block.
1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the TILT block. (Refer to Section 1-4-3.)
3. Remove the side cabinet and camera cabinet. (Refer to steps 3 to 9 in Section 1-4-8.)
4. Remove the CN-3521 board. (Refer to Section 1-4-9.)
5. Remove the FCB assembly. (Refer to Section 1-4-10.)
6. Rotate the FCB holder in the direction of the arrow.
7. Remove the four screws, then remove the two center cabinets.
FCB holder
After the FCB holder is
rotated, the stepping motor
assembly is positioned as
shown in this illustration.
Center cabinet
8. To install, reverse the removal procedure.
SNC-WR632C/WR602C
BTP
2.6
8
BTP
2.6
8
Center cabinet
1-21 (E)