Sony SNC-WR632C Service Manual page 22

10. Disconnect the harness from the connector (CN904) on the CN-3521 board.
11. Rotate the camera block in the direction of the arrow.
12. Remove the two screws, then remove the DC fan.
DC fan
BVTP
3 16
Harness
Label side
13. To install, reverse the removal procedure.
n
. Attach the DC fan with the label side facing the direction as shown in the illustration.
. Route and connect the harness of the DC fan through the notch.
1-18 (E)
Camera block
After the camera block is
rotated, the stepping motor
assembly is positioned as
shown in this illustration.
Route the harness through this notch.
CN904
CN-3521 board
Harness
SNC-WR632C/WR602C