Sony SNC-WR632C Service Manual page 11

6. To install, reverse the removal procedure.
n
. When attaching the sunshade, pass the wire (O) through the portion A in Fig. 1.
. When attaching the top unit assembly, rotate the cover (TM) as far as it will go in the direction of
the arrow, and adjust the connector on the TM-61 board to the position as shown in Fig. 2.
. When attaching the top unit assembly, align the portion B of the top unit assembly with the convex
portion of the out cabinet, then securely insert the connector on the TM-61 board into the connector
on the IF-1232 board. (Fig. 3)
. When attaching the top unit assembly, check that the O-ring (TOP) is securely fitted in the groove
of the out cabinet without being twisted. (Fig. 4)
Fig. 1
Sunshade
Portion A
Wire (O)
Fig. 2
Back side of top unit
assembly
Connector
SNC-WR632C/WR602C
Fig. 3
Top unit assembly
Fig. 4
O-ring (TOP)
Cover (TM)
TM-61 board
TM-61 board
Portion B
IF-1232 board
Out cabinet
Convex portion
Out cabinet
Connectors
Groove
1-7 (E)