Table of Contents
Advertisement
17. To install, reverse the removal procedure.
n
. When attaching the PAN pulley, align the boss of the PAN shaft assembly with the hole of the PAN
pulley.
. When attaching the timing belt, loosen the two screws of the stepping motor assembly (PAN), then
fully tighten the screws while pushing it in the direction of the arrow.
. Attach the timing belt so that the tension of its timing belt is the same as that of the stepping motor
assembly (TILT).
. When attaching the timing belt, rotate the PAN pulley five times in the direction of the arrow so that
the timing belt comes in contact with the guide of the PAN pulley.
Timing belt
1-30 (E)
PAN pulley
PAN pulley
Guide
Timing belt
SNC-WR632C/WR602C
Hide quick links:
Advertisement
Table of Contents
