Service Overview; Board Location; Removal Of Cabinet - Sony DXC-390 Service Manual

2-1. Board location

EN-142/142P
board
DP-313/313P
board
VA-193/193P
board
PA-236 board
P2 x 3
CCD block
DXC-390/390P
Section 2
Service Overviw
SG-265/265P
board
CN-1938 board
MB-875/875P
board
P2 x 3
Upper case
*4
P2 x 3
*1
*3
P2 x 3
P2 x 3
Stay
*3
B3 x 8

2-2. Removal of cabinet

1. Remove the seven screws (P2 x 3) and then remove
the upper case.
2. Remove the two screws (P2 x 3) and then remove the
stay.
3. Remove the two screws (P2 x 3) and then remove the
rear panel.
Remove the flat cable from the rear panel.
4. Loosen the three screws (B3 x 8) and then remove the
tripod adaptor. (These screws cannot be removed
because of stoppers.)
5. Remove the CCD block, referring to the Section2-3.
"Removal of CCD block".
6. Remove the flat cable from the SG-265/265P board.
7. Remove the four screws (P2 x 3) on the MB-875/875P
board and then remove the lower case.
n
Do not damage the flat cable.
SG-265/265P
board
VA-193/193P
P2 x 3
board
*2
Flat cable
*2
Lower case
*1
P2 x 3
B3 x 8
Tripod adaptor
*4 Rear panel
Flat cable
MB-875/875P board
2-1 (E)