Fcb Assembly - Sony SNC-WR632C Service Manual

1-4-10. FCB Assembly

1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the TILT block. (Refer to Section 1-4-3.)
3. Remove the side cabinet and camera cabinet. (Refer to steps 3 to 9 in Section 1-4-8.)
4. Remove the CN-3521 board. (Refer to Section 1-4-9.)
5. Remove the two screws (BSW2 x 6), then remove the front cabinet.
6. Remove the four screws (PSW2 x 6), then remove the FCB assembly.
7. Disconnect the flexible flat cable from the connector on the FCB assembly.
FCB assembly
BSW
2 6
Front cabinet
8. To install, reverse the removal procedure.
1-20 (E)
Connector
Flexible flat cable
PSW2 6
SNC-WR632C/WR602C