Sony SNC-WR632C Service Manual page 28

Installation
1. Connect the slip ring harness to the connector (CN103) on the MD-151 board.
2. Twist the slip ring harness by rotating the MD-151 board in the counterclockwise (3) direction two
turns.
3. Install the MD-151 board, then tighten the screws a and then b.
n . Be careful not to catch the harness and flexible flat cable.
. Route the PAN motor harness as shown in the illustration.
4. Connect the flexible flat cable to the connector (CN101) on the MD-151 board.
5. Connect the pan motor harness and tilt motor harness to the connectors (CN401 and CN501) on the
MD-151 board.
6. Tuck the extra length of the pan motor harness behind the MD-151 board.
7. Connect the fine-wire coaxial cable to the connector (CN102) on the MD-151 board.
8. Pull out the extra length of the tilt motor harness, then twist it two turns and tuck in the tilt chassis.
9. Check that the slip ring harness has no contact with IC on the MD-151 board.
CN103
MD-151 board
TILT chassis
Bottom side
MD-151 board
10. Assemble this unit in the reverse order of steps 1 to 3 in "Removal".
1-24 (E)
Slip ring harness
TILT motor harness
IC
Slip ring harness and
TILT motor harness
MD-151 board
CN401
PAN motor
harness
Hook
BTP2.6 8
(Screw b)
Slip ring harness
Fine wire coaxial
cable
BTP2.6 8
(Screw a)
CN501
TILT motor
harness
CN101
Flexible flat
cable
CN102
SNC-WR632C/WR602C