Sony SNC-WR632C Service Manual page 30

11. Remove the screw (BTP2.6 x 8), then remove the TILT bearing plate and ball bearing (L-1680).
12. Remove the two screws (BTP2.6 x 8), then remove the flexible flat cable and TILT pulley.
13. Remove the four hooks, then remove the TILT harness guide.
14. Remove the fine-wire coaxial cable.
n
Attach the fine-wire coaxial cable to the TILT harness guide as shown in the illustration.
15. Remove the three screws (PSW2.6 x 6), then remove the TILT shaft assembly.
Fine-wire coaxial cable
TILT shaft
assembly
FCB holder
Wrap the flexible flat cable 3 and
1/4 turns.
16. To install, reverse the removal procedure.
1-26 (E)
TILT harness guide
Hooks
Hooks
TILT pulley
PSW
2.6 6
Fine-wire coaxial cable
Attach the fine-wire
coaxial cable so that the
taped portion is placed
between the hooks.
Taped portion
TILT harness guide
BTP
2.6 8
Flexible flat cable
Ball bearing (L-1680)
TILT bearing plate
45 mm
BTP
2.6 8
SNC-WR632C/WR602C