Slip Ring Assembly (G6) - Sony SNC-WR632C Service Manual

1-4-15. Slip Ring Assembly (G6)

1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the TILT block. (Refer to Section 1-4-3.)
3. Remove the HC-51 board. (Refer to Section 1-4-5.)
4. Remove the SY-416 board. (Refer to Section 1-4-6.)
5. Remove the PS-858 board. (Refer to Section 1-4-7.)
6. Remove the DC fan. (Refer to Section 1-4-8.)
7. Remove the CN-3521 board. (Refer to Section 1-4-9.)
8. Remove the FCB assembly. (Refer to Section 1-4-10.)
9. Remove the center cabinet. (Refer to Section 1-4-11.)
10. Remove the MD-151 board. (Refer to Section 1-4-12.)
11. Rotate the FCB holder in the direction of the arrow.
12. Remove the screw, then remove the PAN harness guide.
13. Remove the three screws, then remove the PAN plate (O).
TILT chassis
PSW2.6
1-28 (E)
PSW2.6 6
PAN harness guide
FCB holder
After the FCB holder is rotated, the stepping motor
assembly is positioned as shown in this illustration.
PAN plate (O)
6
Stepping motor assembly (PAN)
Screws
SNC-WR632C/WR602C