Table of Contents
Advertisement
2.5.5 Communication error
Communication errors may occur when the condition of a particular phone circuit happens to be bad at
the time of attempting the communication job. Therefore, do the communication over again. If communica-
tion errors occur too many times, prepare another (known good) facsimile unit and check the communica-
tion condition among the three facsimile units, thus analyzing the troubles.
DP1600 series
DP2000/2500 series
1. If normal communications are possible between A and C, and the communication trouble occurs B
and C, it can be assumed that B facsimile is malfunctioning.
2. If normal communications are possible between B and C, and the communication trouble occurs A
and C, it can be assumed that A facsimile is malfunctioning. Therefore, adjust the transmission attenu-
ator value (FUNC4 & 28) and the cable equalizer value (FUNC5).
3. If normal communications are possible between A and C and between B and C, it can be assumed
that there is a problem in the line between A and B. Ask the applicable organization (telephone com-
pany, etc.) to check the telephone line.
GD-1060 TROUBLESHOOTING
A communication error occurs between A and B.
Known good facsimile
2 - 8
Remote facsimile unit
January 2001 © TOSHIBA TEC
Advertisement
Table of Contents
