Toshiba GD-1060 Service Handbook page 7

Code
Maintenance User
C2 85
C3 83
C4 83
D0 80
D1 82
D2 86
E0 21
E6 21
F0 83
F1 83
GD-1060 ADJUSTMENT ITEMS
Cause
After detecting the image signal, car-
rier off was detected on the receiving
side.
After detecting a high-speed signal,
EOL was not detected on the receiv-
ing side.
The EOL timer has timed out.
Post response signal was not detected
on the sending side.
Post signal was not detected on the
receiving side.
DCN is received.
RTN/PIN/ERR is received on the
sending side.
RTN/PIN/ERR is received on the re-
ceiving side.
A printer error occurred during a re-
ception, and the machine is shifted
into memory reception mode. How
ever, there was not enough residual
memory.
An error relating to the printer has oc-
curred.
The communication ended because of
a watchdog timer due to an overrun
of the software.
The communication ended because of
an overrun of the software due to hard-
ware noises.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Attempt the transmission
again. Or ask the remote party to attempt
the transmission again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
This may happen in some cases of bad
line condition. Ask the remote party to
transmit again.
Remove the cause of the printer error,
then ask the remote party to transmit
again.
Confirm details of the error using the er-
ror code and correct the error. Then ask
the remote party to transmit again.
Attempt the communication again. If the
error occurs frequently, perform a
memory clear (except user area.)
Attempt the communication again. If the
error occurs frequently, perform a
memory clear (except user area.)
1 - 4
Remedy
January 2001 © TOSHIBA TEC